Specifications

C.2. LIST OF UPLINK COMMANDS
C.2 List of Uplink Commands
All commands are issued in the form
COMMAND “space” ARGUMENT 1 “space” ARGUMENT 2 ... “CR”.
Commands requiring numeric arguments must be zero padded. For example,
to request record number eight, the command:
get record 08
must be issued, rather than get record 8. Table C.2 shows the complete lis t
of accepted commands and the arguments that they require.
C.3 PCB Design
Figure C.1 shows the top solder side and Figure C.2 shows the bottom solder
side. Figure C.3 shows a reduced circuit schematic. The full-size schematic
is available on the attached CD in A3 size. Figure C.4 shows the partially-
populated prototype board used throughout this project for evaluation.
C-3