User manual
Wavecom GSM Modem
This confidential document is the property of WAVECOM and may not be copied or circulated without permission
52
9. Failure result codes
9.1. Report Mobile Equipement errors +CMEE
This command disables or enables the use of result code
+CME ERROR : <xxx> or +CMS ERROR :<xxx>
Application to GSM AT+CMEE=0 disable « +CME ERROR : <xxx> »
and use « ERROR » instead
GSM to application OK
Application to GSM AT+CMEE=1 enable « +CME ERROR : <xxx> »
GSM to application OK
9.2. Extended error report +CEER
If the last call setup (originating or answering) fails, this command gives
the reason of the call release.
Application to GSM ATD123456789 ; outgoing voice call
GSM to application NO CARRIER
Application to GSM AT+CEER ask for reason of release
GSM to application +CEER : Error <xxx>
OK
<xxx> is the cause information
element values from GSM
recommandation 04.08
The cause information element from GSM 04.08 is given below.