User guide

CM52 Integrators’ Manual
CM52 Integrators’ Manual
WI_DEV_CM52_UGD_001-001
Page 50 of 53
This document is the sole and exclusive property of WAVECOM. Not to be distributed or divulged without prior written agreement.
Ce document est la propriété exclusive de WAVECOM. Il ne peut être communiqué ou divulgué à des tiers sans son autorisation préalable
5 Hints for Integrating the Wireless CPU
®
This section, which gives you advice and helpful hints on how to integrate the CM52 with the
application, should be taken as a guide.
Note!
The circuits on the test board are not shielded. Therefore take proper precautions for
avoiding ESD and EMI.
5.1 Precautions
Following is a list of preparations that you should make before beginning the integration work that
is described in this section.
Where to install the Wireless CPU
®
Safety standards
Network and subscription
Antenna
5.2 Where to Install the Wireless CPU
®
Make sure that the Wireless CPU
®
is installed in proper environmental conditions such that
temperature, humidity, vibration, etc., are not beyond the limits specified for it.
Make sure that the signal strength is sufficient. To improve signal strength, move the antenna to
another position. Signal strength may depend on how close the Wireless CPU
®
is to a radio base
station. Degradation in signal strength could be a result of disturbance from another source, for
example, an electronic device nearby.
You can verify signal strength by issuing the AT command AT+CSQ. See the CM52 Software User’s
Guide and AT Command Manual for a description of this and other useful AT commands.
Tip! Before installing the Wireless CPU
®
, use an ordinary mobile telephone to check a possible
location for it. Consider signal strength as well as cable length in determining the location for the
Wireless CPU
®
and antenna. That way you will find out if it is practical to install the Wireless CPU
®
where you intended.
5.3 Safety Standards
You are responsible for observing your country’s safety standards and the relevant wiring rules,
where applicable.