User guide

CM52 Integrators’ Manual
WI_DEV_CM52_UGD_001-001
Page 17 of 53
CM52 Integrators’ Manual
2.2.3.2 Mounting Configuration B
Mounting configuration “B” uses four 3/4 mounting holes that support #6 size screws.
Figure 8: Mounting Configuration B
Note: This is the recommend mounting configuration due to the higher mechanical vibration
specification supported.
2.2.4 RF Connector Mounting Considerations
When designing the application the designer should ensure that the housing does not degrade the
RF performance of the CM52. A minimum clearance of 4mm from the surface of the PCB to the
housing on the back side of the RF connectors should be provided.
4mm
Figure 9: Application Housing
This document is the sole and exclusive prope
r
ty of WAVECOM. Not to be distributed or divulged without prior written agreement.
Ce document est la propriété exclusive de WAVECOM. Il ne peut être communiqué ou divulgué à des tiers sans son autorisation préalable