Specifications

Wireless CPU
®
Q24 Series
Interfaces
©Confidential Page: 25 / 83
This document is the sole and exclusive property of WAVECOM. Not to be distributed or divulged without
prior written agreement.
WM_PRJ_Q24NG_PTS_001-004
January 16, 2007
3.2.3.1 Power Consumption without Open AT
®
Processing
The following measurement results are relevant only when:
• There is no Open AT
®
application,
• The Open AT
®
application is disabled,
• No processing is required by the Open AT
®
application.
Operating mode Parameters
INOM
average
IMAX
average
IMAX
peak
Unit
OFF Mode VBATT= 3.6V 16.5 18 μA
Alarm Mode VBATT= 3.6V 18.5 20 μA
Paging 9 10.5 11 150
Rx
mA
Fast Idle Mode
Paging 2 13 13.5 150
Rx
mA
Paging 9 2.8 3 150
Rx
mA
Slow Idle Mode
Paging 2 5.5 5.8 150
Rx
mA
Fast Standby VBATT = 3.6V 9.5 11 - mA
Slow Standby VBATT = 3.6V 1.5 2 - mA
PCL5 217 225 1400
Tx
mA GSM850
EGSM900
PCL19 90 95 250
Tx
mA
PCL0 165 175 800
Tx
mA
Connected Mode
DCS1800
PCS1900
PCL15 90 100 250
Tx
mA
Gamma 3 209 220 1400
Tx
mA GSM850
EGSM900
Gamma 17
87 90 250
Tx
mA
Gamma 3 150 170 800
Tx
mA
Transfer Mode
Class 8 (4Rx/1Tx)
DCS1800
PCS1900
Gamma 18
84 95 250
Tx
mA
Gamma 3 380 410 1400
Tx
mA GSM850
EGSM900
Gamma 17
130 160 270
Tx
mA
Gamma 3 258 290 800
Tx
mA
GPRS
Transfer Mode
Class 10 (3Rx/2Tx)
DCS1800
PCS1900
Gamma 18
123 150 240
Tx
mA
TX
means that the peak current is measured during a TX transmission burst
RX
means that the peak current is measured during a RX reception burst
1
Slow Idle mode power consumption depends on the SIM Card used.
Some SIM Cards respond faster than others, the longer the response time, the higher
the consumption. The measurements were performed on a large number of 3V SIM
Cards and the results in brackets shown in the above table are the minimum and
maximum currents measured from among all the SIM Cards used.