User guide

WM_PRJ_M12_UGD_001 - 002
18th September 2003
confidential ©
Page :
25 / 38
This document is the sole and exclusive property of WAVECOM. Not to be distributed or divulged
without prior written agreement.
Ce document est la propriété exclusive de WAVECOM. Il ne peut être communiqué ou divulgué à
des tiers sans son autorisation préalable.
4 Using the modem
4.1 Getting started with the modem
4.1.1 Mounting the modem
To mount the modem, bind it using the holding bridles as shown in the
diagram below.
Figure 9: Modem mounting
4.1.2 Setting up the Fastrack modem
To set up the modem, do the following:

Press SIM card holder ejector (yellow button) with a sharp object (the
tip of a pen for example).

Insert the SIM card in the holder.

Verify the SIM card fits in the holder properly.

Connect the antenna to the SMA connector.

Connect both sides of the serial and control cable (15-pin Sub HD
connector on the modem side).

Connect the power supply cable to the power supply source.
Note: for automotive application, it is recommended to connect the
V+BATT line of the modem directly to the positive terminal of the
battery.

Plug the power supply cable into the modem and switch on the
external power supply.

Now the modem is ready to work. Refer to chapter 5 for some AT
commands to configure the modem.