Specifications

RT9 Powershelf Rectifier Technologies
158-1806-01.doc
39 2-Mar-06
• If the new address is listed, click “Save” button. Details of new device will be added to
the DeviceInstaller data base.
• If the new address is NOT listed, repeat the programming procedure.
7.1.3 Preparations for gateway address set up
• From your network administrator obtain the gateway IP address
• Connect a PC to the controller’s network interface (directly or via a network).
• Power-up the controller.
• Start DeviceInstaller program.
7.1.4 Gateway IP address set up procedure
• In DeviceInstallr device list select the address of the unit you want to configure.
• On DeviceInsteller tool bar click “Manage device configuration button”. A new window
“Device Management” will open.
• Click “Telnet to Device” button.
• Telnet window will open, showing a message similar to the one below:
*** Lantronix Cobox Universal Device Server ***
Serial Number 1297-041 Software Version V03.9 (000211)
Press Enter to go into Setup Mode
Note: If Enter is not pressed within 3 seconds the connection will be terminated.
• If Enter was pressed within time-out window, a message similar to the sample below will
be printed to Telnet window:
*** basic parameters
Hardware: Ethernet Autodetect
IP addr 192.168.000.098, no gateway set
***************** Channel 1 *****************
Baudrate 09600, I/F Mode 4C, Flow 00
Port 10001
Remote IP Adr: --- none ---, Port 00000
Connect Mode: C0 Disconn Mode: 00
Flush Mode: 00
Change Setup : 0 Server configuration
1 Channel 1 configuration
7 Factory defaults
8 Exit without save
9 Save and exit Your choice ?