User's Manual

HARDWARE INSTALLATION
Basic Configuration Setup
3-8 P-Com DataMetro II
3
 8VHDFURVVRYHUQXOOPRGHPFDEOHZLWKD'%PDOHFRQQHFWRURQ
RQHHQGWRFRQQHFWWRWKHUDGLRDQGDQDSSURSULDWHFRQQHFWRUDWWKH
FRPSXWHUHQG
Figure 3-5 Connecting the Terminal or PC
5 7XUQRQWKHWHUPLQDORUFRPSXWHUDQGVWDUWWKHWHUPLQDOVHVVLRQ
6 &RQQHFWSRZHUWRWKH'DWD0HWUR,,XQLW6HH)LJXUH 
Figure 3-6 Connecting the Power Cord
 3OXJWKH$&SRZHUFRUGLQWRWKHSLQFRQQHFWRURQWKHEDFNRIWKH
UDGLR
 3OXJWKHSURQJHQGRIWKH$&SRZHUFRUGLQWRDJURXQGHGHOHFWULFDO
RXWOHW
7RDYRLGHOHFWULFDOVKRFNRUSRZHUORVVHQVXUHWKDWWKHSRZHUFRUGLV
VHFXUHO\FRQQHFWHGWRWKHXQLW'RQRWXVHDSROHWRSROHDGDSWHU
ZLWKWKHSOXJ9HULI\WKDWWKHRXWOHW\RXLQWHQGWRXVHLVSURSHUO\LQVWDOOHG
DQGJURXQGHGWKHRXWOHWXVHGPXVWFRPSO\ZLWKWKHORFDOHOHFWULFDO
FRGHIRU\RXUFRXQWU\
 7XUQWKH$&SRZHUVZLWFKWR216HH)LJXUH 
After power-on the unit will run a power-on-self-test (POST).
This test takes about 40 seconds to complete. Successful
completion of the POST causes the 7-bank LEDs on the front of
the radio to flicker before going to a steady state.
If you have successfully connected to the radio, the terminal will
display the
'DWD0HWUR! prompt and an initial message.
GND
RESET
COM1
MODEM
TERMINAL
ETHERNET
U
L
GND
POWER
RESET
COM1
MODEM
TERMINAL
ETHERNET
U
L
AC Power Cord
AC Power
On/Off Switch
(| = On, O = Off)