User's Manual

. . . . .
HARDWARE INSTALLATION
Basic Configuration Setup
Hardware Installation Guide 3-7
 6HWWKHWRSRORJ\DFFRUGLQJWR7DEOH 
5 6HW6ZLWFK³$QWHQQD$OLJQPHQWWR2))
6 6HW6ZLWFK³5HVHW&RQILJXUDWLRQWR2))
:KHQ\RXPRYHWKH'DWD0HWUR,,XQLWIURPRQHQHWZRUNWRDQRWKHU\RX
ZLOOQHHGWRUHVHWWKHPRYHGXQLW·VFRQILJXUDWLRQE\VHWWLQJVZLWFKWR
21
&200$1'/,1(,17(5)$&(
The P-Com Data Metro II radio can be configured through a
command line interface running on a terminal (or a PC running a
terminal emulation program).
Before connecting the terminal to the radio, configure the
terminal with the following settings:
• Baud rate = 9600
•Data bits = 8
• Parity = None
• Stop bits = 1
• Flow control = Hardware
If you are using a PC or laptop computer, refer to the operating
system documentation for instructions on how to configure and
run the terminal emulation program.
7RVHWXSWKHUDGLR
1 5HPRYHWKHUDGLRIURPWKHVKLSSLQJFDUWRQ
2 5HPRYHWKHVZLWFKSODWHIURPWKHIURQWRIWKHUDGLR6HH)LJXUHRQ
SDJH 
3 0DNHVXUH$//WKH',3VZLWFKHVRQWKHIURQWRIWKHUDGLRDUHLQWKH2))
SRVLWLRQ7KLVLVWKHPDQXIDFWXULQJGHIDXOW
 7RVHWWKHVZLWFKWRWKH2))SRVLWLRQSXVKWKHVZLWFKGRZQWRZDUGWKH
ERWWRPRIWKHUDGLR
4 &RQQHFWWKHWHUPLQDORU3&WRWKH'%56FRQQHFWRURQWKHEDFN
RIWKHUDGLR6HH)LJXUHRQSDJH 
Table 3-3 Topology Switch Positions
Switch
Topology 9 10
Star Remote ON ON
Star Base ON OFF
Peer-to-Peer OFF ON
Point-to-Point OFF OFF
127(
✐