User Manual

RACK MOUNTING
19 inch Rack Mount
4-2 P-Com AirPro Gold
4
To mount the unit in a rack, you need:
• two rack-mount brackets (supplied)
• screws and washers to attach the brackets to the unit (supplied)
• 1/4 inch hex nut driver or wrench
• screwdriver
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
19 INCH RACK MOUNT
Refer to Figure 4-2 when mounting the unit in a 19 inch equipment rack.
Figure 4-2 Brackets for 19 inch Rack Mount
To mount the unit in a 19 inch rack:
1 Choose the front, center, or rear rack mount position for the unit.
2 Place a bracket on the chassis in the chosen position so that the bracket holes
line up with the threaded inserts on the side of the chassis, and the short flange
faces the front of the unit for the front or center position mount, or the back of
the unit for the rear position mount.
3 Attach the bracket to the chassis.
• Use two of the screws, lock washers, and flat washers supplied with the unit.
4 Repeat Step 2 and Step 3 to attach another bracket on the opposite side of the
chassis.
5 Attach the bracketed chassis to the rack posts. Refer to Figure 4-1 on page 4-1.
• Align the front flanges of the brackets with the screw holes on the rack posts.
Front
Position
Center
Position
Rear
Position
Flat Washer
Lock Washer
Hex Head Screw
6-32 x 3/8 inch
APG2_004
RSQ/RSSI
Alarm
Link
Frame TX
Ethernet Link
Ethernet Activity
Power