User Manual

. . . . .
HARDWARE INSTALLATION
Basic Configuration Setup
Hardware Installation Guide 3-5
• RF channel—all units in a common network must use the same RF
channel. Separate WANs in the same geographic area may need to
use different channels (to eliminate interference). AirPro Gold
provides 13 channels.
• Topology—AirPro Gold provides these topologies: peer-to-peer,
point-to-point, centralized (star base and star remote)
• Configuration Reset—to install the basic configuration
You can set up a basic radio configuration using one of three methods:
• through DIP switch positions
• through a terminal command line interface
• through the Site Manager software application
DIP SWITCHES
AirPro Gold can be configured through a block of twelve OFF/ON DIP
switches located on the front of the unit behind the switch plate. See
Figure 3-4.
Figure 3-4 DIP Switches
• To set the switch to the ON position, push the switch up toward the top of the
unit.
• To set the switch to the OFF position, push the switch down toward the bottom
of the unit.
To set up a basic unit configuration using the DIP switches:
1 Remove the unit from the shipping carton.
2 Place the unit on a flat surface so that the front is easy to reach.
APG2_022
123456789101112
O
N
ON-CONFIGURATION RESET
RF CHANNEL
SEE COVER LABEL
ON-ANTENNA ALIGNMENT
MODE
OFF-NORMAL MODE
1
1
2
2
34
4
5678
8
12
48
9101112
RF CHANNEL MUST BE SELECTED USING
BINARY FORMAT (1 - ON, 0 - OFF)
TO CONFIGURE BY SOFTWARE OR TERMINAL ALL 12
SWITCHES MUST BE OFF
STAR REMOTE
STAR BASE
PEER-TO-PEER
POINT-TO-POINT
TOPOLOGY
ON
OFF
ON
OFF
ON
ON
OFF
OFF
109