User Manual

AirLink Pro T1/E1 Rack Mount Installer’s Guide

Configuration

Rev. B - 1/97

3-36

SET DIAL PULSE <RETURN>

The default setting is TONE.

Dial Retry

If the unit dials an alarm and reaches a busy or no answer signal, the unit will

dial a second number if one is specified. Both numbers are dialed before a

holdoff period is imposed. There is no automatic retry when the unit is

configured for manual dialing.

To set the holdoff period before the unit dials the first number again, type the

command:

SET DIAL RETRY XXX <RETURN>

where XXX is the period in (15 - 3600) seconds. The default is 60.

Modem (Enabling) Mode

This is the modem operation mode that is described in the section Using the

Network Management (Modem) Port. To set this mode, type the command:

SET MODEM MODE {DISABLED | DEDICATED | DIAL_OUT | ANSWER | BOTH}

The default is DISABLED.

Modem Rate

This is the bit rate of the modem port. To set this parameter, type the

command:

SET MODEM RATE {1200 | 2400 | 4800 | 9600}

The default is 9600.

Modem RTS Mode

This mode governs whether the modem port RTS line is permanently asserted,

or switched on only when the port is sending characters. The RTS line is not

needed for use with smart modems. To change the mode, type the following

command:

SET MODEM RTS {SWITCHED | CONTINUOUS}

The default mode is CONTINUOUS.