User Manual

AirLink Pro T1/E1 Rack Mount Installer’s Guide
Configuration
Rev. B - 1/97
3-33
User Interface Additions
Table 3-4
Modem Commands
Parameter Specification
SET ALARM HOLDOFF 0-600 (seconds)
SET ANSWER TIMEOUT 0-99 (seconds)
SET CONNECTION TIMEOUT 0 - 43200 (seconds; 0 means no time-out)
SET DIAL {TONE | PULSE}
SET DIAL HOLDOFF 0-5000 (minutes, repeat dial holdoff)
SET DIAL LEVEL {FAULT | ALARM | ADVISORY | STATUS}
SET DIAL RETRY 15-3600 (seconds)
SET MODEM MODE {DISABLED | DEDICATED DIAL_OUT | ANSWER | BOTH}
SET MODEM RATE {1200 | 2400 | 4800 | 9600}
SET MODEM RTS {SWITCHED | CONTINUOUS}
SET MODEM CTS {OBEY | IGNORE}
SET MODEM DTR {SWITCHED | CONTINUOUS}
SET MODEM VOLUME {OFF | LOW | MEDIUM | HIGH}
SET MODEM XOFF {OBEY | IGNORE}
SET PHONE 1 (XXX) XXX-XXXX
SET PHONE 2 (XXX) XXX-XXXX
SET REPEAT COUNT 0-99
SET RINGCOUNT 0-9
The GET MODEM command retrieves all of the Modem Command parameters.
This command produces a screen displaying all of the settings, the dial-out
status, and the date and time. In addition, all the SET and GET commands are
available via the REMOTE prefix.
The following commands are also supported:
CONNECT 1 manual connect
CONNECT 2 manual connect
CONNECT telephone-number manual connect
DISCONNECT manual disconnect