User Manual

AirLink Pro T1/E1 Rack Mount Installer’s Guide
Installation and System Administration
Rev. B - 1/97
2-10
The AirLink Pro T1/E1 Rack Mount can be installed into a standard 19-inch or
23-inch equipment rack using the rack-mount hardware included with the unit.
It requires 4U (7.0”) of rack mounting space, of which 1U space above and below
the unit is necessary for proper ventilation. Two standard blank panels can be
used over the openings.
To mount the AirLink Pro T1/E1 Rack Mount in an equipment rack:
1. Place the AirLink Pro T1/E1 Rack Mount on a table or bench.
2. Lay out the pieces of the rack mount hardware kit.
The rackmount hardware kit should contain the following parts:
❚ Two 1-inch increment mounting brackets for 23-inch rack mount
❚ Two EIA mounting brackets for 19-inch rack mount
❚ Eight 10-32 x 3/8” Phillips pan-head screws, lock washers, and flat
washers
3. Orient the mounting brackets for front- or mid-mounting.
4. Attach the brackets to the AirLink Pro T1/E1 Rack Mount with the screws
provided in the hardware kit.
5. Position the AirLink Pro T1/E1 Rack Mount in the equipment rack and
fasten with screws.