User Manual

AirLink Pro T1/E1 Rack Mount Installer’s Guide
Installation and System Administration
Rev. B - 1/97
2-4
Table 2-1
AirLink Pro T1/E1 Rack Mount Rear-Panel Connectors
Connector Type Function
Network Management 9-Pin Male
Subminiature D
Connects a modem to the AirLink Pro
T1/E1.
Terminal RJ - 11 Terminal connection
CSU 6-Pin Captive
Wire Terminal
Block
Connects the T1/E1 Line from an external
device such as a CSU. Used for wire line
backup only.
E1 Out BNC Not used for T1 unit; In E1 unit, used for
configuring Unbalanced Interface option
DTE 4-Pin Captive
Wire Terminal
Block
T1/E1 connection to the DTE
E1 In BNC Not used for T1 unit; In E1 unit, used for
Unbalanced Interface option
Order Wire 4-Pin Captive
Wire Terminal
Block
Connection for Four wire Order Wire unit
BSYNC 6 Pin Captive
Wire Terminal
Block
Burst sync connection
Minor Alarm 4-Pin Captive
Wire Terminal
Block
Minor alarm relay connection
Major Alarm 6-Pin
CaptiveWire
Terminal Block
Major alarm relay connection
Power 6-Pin Captive
Wire Terminal
Block
Power connection
Antenna N type female Antenna connection
Preparing a Place
Because of the special planning requirements associated with installing a
microwave system, review some of the general guidelines regarding
installation preparation to ensure that the site is suitable to the purpose.