User Manual

AirLink Pro T1/E1 Rack Mount Installer’s Guide
Index
Index-2 Rev. B - 7/97
A
acquiring alarm information, 4-5
administrative parameters
date, 3-10
password, 3-11
site name, 3-9
time, 3-10
AirLink T1/E1
ASCII Terminal Interface, 1-4
features and capabilities, 1-3
front panel, 2-3
AirLink T1/E1 alarm control parameters
1-hour ES threshold, 3-23
1-hour UAS threshold, 3-23
24-hour ES threshold, 3-24
24-hour UAS threshold, 3-24
alarm level, 3-22
alarm reporting, 3-21
Rx power threshold, 3-25
Tx power threshold, 3-25
AirLink T1/E1 line parameters
coding, 3-12
equalization, 3-12
summary, 3-12
AirLink T1/E1 Link parameters
application, 3-14
burst mode, 3-18
PN code, 3-19
RF power level, 3-20
AIS,4-4
DTE, 4-4
RF, 4-4
alarm control
alarm level, 3-22
alarm reporting, 3-21
ES threshold, 3-23
Rx power threshold, 3-25
Alarm Indication Signal. (see AIS). (see AIS)
alarm relay contacts, 1-6, 2-10
Alternate Mark Inversion. (see AMI)
AMI, 1-4, 4-12
antenna
mounting schemes, 2-6
antenna alignment, 2-18
ASCII terminal interface
command replies, 4-5
command-line mode, 4-3
terminal cable, 4-2
B
B8ZS, 1-2, 3-12
battery, 1-5
BER
QRSS, 4-10
block diagram, 1-8
Bipolar 8-Zero Substitution. (see B8ZS)
burst mode, 3-18
burst sync loss, 4-2
burst sync
installing, 2-20
terminating, 2-21
C
carrier failure alarms,4-5
checking operation, 2-21
coaxial cables, 2-12
coding, 3-12
command-line mode
case treatment,3-4
comments, 3-4
keyword short forms, 3-4
length, 3-4
order, 3-4
commands
get configuration, 3-26
get revision, 3-27
get threshold, 3-27
keylist, C-2
login, C-6
logout, C-6
password, 3-11
query alarms, 4-6
query performance, 4-9
query status, 4-2
reset alarms, 4-7
reset QRSS, 4-12
configuration defaults, B-20
D
date command, 3-6
DCE, 1-3
determining configuration parameters 3-37
diagnostic tools, 4-12
DTE, 1-3
DTE AIS, 4-4
E
electromagnetic interference (EMI), B-3
environmental requirements
temperature, B-2
humidity, B-2
altitude, B-2
equalization, 3-12
equalization command, C-2
Errored Seconds. (see ES)
event queue, 4-5