User Manual

Airlink Pro T1/E1 Rack Mount Installer’s Guide
Commands
Rev. B - 1/97
C-6
AIRLINK PRO T1/E1> login
NOTE Throughout this manual, the command line prompt AIRLINK PRO T1> represents the
E1 command line prompt AIRLINK PRO E1>.
The system prompts you to enter the password. If the password is accepted, the
system displays an OK response and gives access to the commands.
To login using the factory-set null password, type the LOGIN command at the
AirLink Pro T1/E1 Rack Mount prompt and press <Return> when the system
prompts you for the password:
AIRLINK PRO T1/E1> login
Password: <Return>
OK
AIRLINK PRO T1/E1>
If the new password is 1Awidget, type the LOGIN command and 1Awidget for
the password:
AIRLINK PRO T1/E1> login
Password: 1Awidget
OK
AIRLINK PRO T1/E1>
For information on changing the password, refer to “Password” in the section
“Setting Administrative Parameters,” in this chapter.
The LOGOUT command keyword exitsthe system and prevents unauthorized
system use. To logout of the local AirLink Pro T1/E1 Rack Mount, type the
following command at the AirLink Pro T1/E1 Rack Mount prompt:
AIRLINK PRO T1/E1> logout
For remote command operations, it is not necessary to login to the remote unit if
you are logged in to the local system.
H e lp
The terminal interface also provides an online help facility to aid you in
entering commands. You can type a question mark (?) at the end of any command
field, and the command interpreter will display the next valid keyword or
operand that you can enter.