User Manual

AirLink Pro T1/E1 Rack Mount Installer’s Guide
Commands
Rev. B - 1/97
C-5
R esponses and Alerts
Each of the following messages is an advisory. These advisories will not
trigger a dial-out, and they are entered into the Event Queue.
"Modem Busy"
"No Modem"
"No Answer"
"No Dialtone"
All numeric responses are followed by <CR> (ASCII 13 decimal). All “word”
responses are followed by <CR> and <LF> (ASCII 10 decimal).
M odem R esponse D efinitions
M odem R esponse D e finition
0 (zero) Numeric version of "OK"
OK Successful execution of non-dial command
CONNECT [XXXX] carrier detected; XXXX = numeric bit rate
RING Ringing detected
NO CARRIER No connection established, or connection lost
ERROR Error in command line
NO DIALTONE No dial tone present
BUSY Busy signal
NO ANSWER 5 seconds of silence not detected if '@' dial modifier was used.
Logging In and Logging O ut
The operator must enter the LOGIN command keyword and provide the correct
password to use the GET, SET, QUERY, RESET, TEST, and REMOTE commands.
NOTE When the unit is prepared for shipment, it is configured with a null password as a default.
To gain access to the system the first time, press <Return> in response to the login
prompt for the password. This password will remain in effect until changed.
To login to the local AirLink Pro T1/E1 Rack Mount, type the following
command at the AirLink Pro T1/E1 Rack Mount prompt: