User Manual

Airlink Pro T1/E1 Rack Mount Installer’s Guide
Operations and Maintenance
Rev. B - 1/97
4-15
When you enter Y (yes) to confirm the request, the system starts the QRSS test.
AIRLINK PRO T1/E1> test qrss
WARNING: Start QRSS test? (Y/N) y
Site Name: Sunnyvale 2
OK
AIRLINK PRO T1/E1>
If you enter N (no) or just press <Return>, the system ignores the event queue
reset request. If you query the performance statistics at this point, you can check
the QRSS BER:
AIRLINK PRO T1/E1> query performance
Site Name: Sunnyvale 2
UWER BER: Unavailable
QRSS BER: 1.6E-07
1 HR ES: 1
1 HR UAS: 0
24 HR ES: 1
24 HR UAS: 0
RSQ: 10
The QRSS Bit Error Rate (BER) is measured from a starting point of 0.00E-99.
The QRSS BER is equal to:
Number of Errors
Test Duration (in seconds)
x
1
1.544 x 10
6
Terminating a QRSS Test
To terminate a QRSS test on the local AirLink Pro T1/E1 Rack Mount, type the
following command at the AirLink Pro T1/E1 Rack Mount prompt:
AIRLINK PRO T1/E1> reset test
The system prompts you to confirm the QRSS test termination request:
AIRLINK PRO T1/E1> reset test
Clear all tests? (Y/N)
When you enter Y (yes) to confirm the request, the system stops the QRSS test.
AIRLINK PRO T1/E1> reset test
Clear all tests? (Y/N) y
OK
AIRLINK PRO T1/E1>