User's Manual
Table Of Contents
- Chapter 1 Introduction
- Features and Benefits
- Features
- Chapter 2 Quick Start
- System Description
- Package Contents
- Installation Steps
- Installation Diagram
- Polarizations on a Grid Antenna
- Chapter 3 Hardware
- Drawings of Components
- Restoring Factory Default Settings on the SPEEDLAN
- Upgrading the Firmware
- Chapter 4 Overview of Configurator
- Installation and Setup
- Toolbar and Menus
- Chapter 5 Configuring SPEEDLAN
- General Setup
- Interface & Advanced Interface Setup
- The Setup Buttons
- Chapter 6 Bridging Setup
- Bridge Setup
- Chapter 7 Setting Up the IP Addresses (IP Host Setup)
- Part I - Quick Overview of IP Addressing
- Part II - Setting Up the IP Address
- Part III - Setting Up NAT
- Chapter 8 IP-Router Setup
- IP Routing Setup
- Chapter 9 SNMP Setup
- SNMP Setup
- Chapter 10 System Access Setup
- System Access Setup
- Chapter 11 SNMP Monitoring
SPEEDLAN Installation and Operation User Guide
9-2 SNMP Setup
SNMP Setup
Choose SNMP Setup from the Setup menu of the SPEEDLAN Configurator to set up SNMP.
• Read Password
This is the read-only password used for SNMP support. It is the SNMP password needed to
read the Flash ROM Configuration and SNMP MIB variables. The factory-default value for
this variable is the string "public".
• Read/Write Password
This is the read/write password used for SNMP support. It is the SNMP password needed to
write the Flash ROM configuration and SNMP MIB variables into the brouter. The string
should be set to a value that is known only by you. The factory-default value for this variable
is the string "public" and should be changed to a string known only to you.
• System Contact
This field should contain the identification of the contact person for this SNMP-managed
node, together with information on how to contact this person.
• System Name
This field should contain the administratively assigned name for this managed node. By