User's Manual

ManualsBrandsWave Wireless Networking ManualsElectronicsSpread Spectrum Transmitter

Table Of Contents

Chapter 1 Introduction
Features and Benefits
- Transparent Ethernet Bridging with Advanced Filtering for Security and Network Reliability
- IP Routing with Advanced Filtering for Security
- SNMP Management
- Wireless Multipoint Protocol
- ISP Functionality
Features
- SNMP Features
- ISP Features
- SNMP Management
- IP-Router Features
- Encryption Features (Add-on Option)
Chapter 2 Quick Start
System Description
- Rooftop and Tower Installations Warning
Package Contents
Installation Steps
Installation Diagram
Polarizations on a Grid Antenna
- Vertical Polarity Horizontal Polarity
Chapter 3 Hardware
Drawings of Components
- SPEEDLAN Front Panel
- SPEEDLAN Back Panel
Restoring Factory Default Settings on the SPEEDLAN
Upgrading the Firmware
Chapter 4 Overview of Configurator
Installation and Setup
- Windows 95/98/NT 4.0 SPEEDLAN Configurator
Toolbar and Menus
- File Menu
- The Toolbar
- The Menu Bar
Chapter 5 Configuring SPEEDLAN
General Setup
Interface & Advanced Interface Setup
- Interface Setup
- Advanced Interface Setup
The Setup Buttons
- Setup 1 Button - Ethernet Setup
- Setup 2 Button - 11 Mb RF Interface Setup
Chapter 6 Bridging Setup
Bridge Setup
- Protocol Filtering
- MAC Filtering
- Advanced Features Button
- Storm Thresholds Button
- Tunnel Partners Button
Chapter 7 Setting Up the IP Addresses (IP Host Setup)
Part I - Quick Overview of IP Addressing
- What is an IP address?
- Internet Address Classes
- Subnetting a Network
- How does a network administrator assign an IP address?
- What is DHCP?
- What is NAT?
- Diagram of Outgoing NAT
- Diagram of Incoming NAT
Part II - Setting Up the IP Address
- Enabling the DHCP Client and Choosing the Appropriate Interface
- Enabling the DHCP Server on the SPEEDLAN
- Assigning a Static IP Address
Part III - Setting Up NAT
- Outgoing NAT
- Incoming NAT
Chapter 8 IP-Router Setup
IP Routing Setup
- Add/Direct Button
- Add/Indirect Button
- More Button - RIP Routing
Chapter 9 SNMP Setup
SNMP Setup
Chapter 10 System Access Setup
System Access Setup
Chapter 11 SNMP Monitoring

SPEEDLAN Installation and Operation User Guide

7-22 Setting Up the IP Addresses (IP Host Setup)

Incoming NAT

To set up incoming IP network address for NAT, do the following:

1 From the Setup menu, choose General Setup. The General Setup dialog box appears.

2 Select the Enable Incoming Network Address Translation check box. Click OK.

3 From the Setup menu, choose Incoming Network Address Translation Setup.