User's Manual
Table Of Contents
- Chapter 1 Introduction
- Features and Benefits
- Features
- Chapter 2 Quick Start
- System Description
- Package Contents
- Installation Steps
- Installation Diagram
- Polarizations on a Grid Antenna
- Chapter 3 Hardware
- Drawings of Components
- Restoring Factory Default Settings on the SPEEDLAN
- Upgrading the Firmware
- Chapter 4 Overview of Configurator
- Installation and Setup
- Toolbar and Menus
- Chapter 5 Configuring SPEEDLAN
- General Setup
- Interface & Advanced Interface Setup
- The Setup Buttons
- Chapter 6 Bridging Setup
- Bridge Setup
- Chapter 7 Setting Up the IP Addresses (IP Host Setup)
- Part I - Quick Overview of IP Addressing
- Part II - Setting Up the IP Address
- Part III - Setting Up NAT
- Chapter 8 IP-Router Setup
- IP Routing Setup
- Chapter 9 SNMP Setup
- SNMP Setup
- Chapter 10 System Access Setup
- System Access Setup
- Chapter 11 SNMP Monitoring
SPEEDLAN Installation and Operation User Guide
Setting Up the IP Addresses (IP Host Setup) 7-3
Internet Address Classes
The first octet defines the "class" of the address, which is the only method to tell the size of the
network (how big) and where the internet address belongs. There are three main classes:
• Class A: 35.0.0.0
• Class B: 128.5.0.0
• Class C: 192.33.33.0
-non-bolded text = Part of network address
-bolded text = Part of local address (node section)
This definition is not random; it is based on the fact that routers, by reading just the first three bits of
the address field, designate which network class it belongs to. This selection simplifies the way
routers handle the messages (packets) and speed up the forwarding process.