User's Manual

ManualsBrandsWave Wireless Networking ManualsElectronicsSpread Spectrum Transmitter

Table Of Contents

Chapter 1 Introduction
Features and Benefits
- Transparent Ethernet Bridging with Advanced Filtering for Security and Network Reliability
- IP Routing with Advanced Filtering for Security
- SNMP Management
- Wireless Multipoint Protocol
- ISP Functionality
Features
- SNMP Features
- ISP Features
- SNMP Management
- IP-Router Features
- Encryption Features (Add-on Option)
Chapter 2 Quick Start
System Description
- Rooftop and Tower Installations Warning
Package Contents
Installation Steps
Installation Diagram
Polarizations on a Grid Antenna
- Vertical Polarity Horizontal Polarity
Chapter 3 Hardware
Drawings of Components
- SPEEDLAN Front Panel
- SPEEDLAN Back Panel
Restoring Factory Default Settings on the SPEEDLAN
Upgrading the Firmware
Chapter 4 Overview of Configurator
Installation and Setup
- Windows 95/98/NT 4.0 SPEEDLAN Configurator
Toolbar and Menus
- File Menu
- The Toolbar
- The Menu Bar
Chapter 5 Configuring SPEEDLAN
General Setup
Interface & Advanced Interface Setup
- Interface Setup
- Advanced Interface Setup
The Setup Buttons
- Setup 1 Button - Ethernet Setup
- Setup 2 Button - 11 Mb RF Interface Setup
Chapter 6 Bridging Setup
Bridge Setup
- Protocol Filtering
- MAC Filtering
- Advanced Features Button
- Storm Thresholds Button
- Tunnel Partners Button
Chapter 7 Setting Up the IP Addresses (IP Host Setup)
Part I - Quick Overview of IP Addressing
- What is an IP address?
- Internet Address Classes
- Subnetting a Network
- How does a network administrator assign an IP address?
- What is DHCP?
- What is NAT?
- Diagram of Outgoing NAT
- Diagram of Incoming NAT
Part II - Setting Up the IP Address
- Enabling the DHCP Client and Choosing the Appropriate Interface
- Enabling the DHCP Server on the SPEEDLAN
- Assigning a Static IP Address
Part III - Setting Up NAT
- Outgoing NAT
- Incoming NAT
Chapter 8 IP-Router Setup
IP Routing Setup
- Add/Direct Button
- Add/Indirect Button
- More Button - RIP Routing
Chapter 9 SNMP Setup
SNMP Setup
Chapter 10 System Access Setup
System Access Setup
Chapter 11 SNMP Monitoring

SPEEDLAN Installation and Operation User Guide

Configuring SPEEDLAN 5-13

Warning: This setting must be set to the same value for the brouters that will be communicating

together. Failure to set them to the same value will prevent any communications from

taking place. For example, in order to use a multipoint link, you must use the same

Encryption setting on the base station and on the CPE brouter.

There is also an option to Deny non-encrypted Data. This feature is disabled by default and is

designed primarily for multipoint SPEEDLAN installations where it may not be necessary to run using

data encryption at all locations. If you enable this option, any data received by this brouter will not

be passed to the wired network interface.