User's Manual
Table Of Contents
- Chapter 1 Introduction
- Features and Benefits
- Features
- Chapter 2 Quick Start
- System Description
- Package Contents
- Installation Steps
- Installation Diagram
- Polarizations on a Grid Antenna
- Chapter 3 Hardware
- Drawings of Components
- Restoring Factory Default Settings on the SPEEDLAN
- Upgrading the Firmware
- Chapter 4 Overview of Configurator
- Installation and Setup
- Toolbar and Menus
- Chapter 5 Configuring SPEEDLAN
- General Setup
- Interface & Advanced Interface Setup
- The Setup Buttons
- Chapter 6 Bridging Setup
- Bridge Setup
- Chapter 7 Setting Up the IP Addresses (IP Host Setup)
- Part I - Quick Overview of IP Addressing
- Part II - Setting Up the IP Address
- Part III - Setting Up NAT
- Chapter 8 IP-Router Setup
- IP Routing Setup
- Chapter 9 SNMP Setup
- SNMP Setup
- Chapter 10 System Access Setup
- System Access Setup
- Chapter 11 SNMP Monitoring
SPEEDLAN Installation and Operation User Guide
Configuring SPEEDLAN 5-11
• Standard
This setting limits the card by providing 2 Mbps of bandwidth. The receiver sensitivity of
the radio with this setting is -89 dBm.
• Low
This setting limits the card by providing 1 Mbps of bandwidth. The receiver sensitivity of
the radio with this setting is -92 dBm.
Warning: This setting must be set to the same value for the brouters that will be communicating
together. Failure to set them to the same value will prevent any communications from
taking place.
Frequency Button - 11 Mb Frequency Setup
The Frequency button is located to the right of the Advanced button. Clicking this button will open a
new dialog box that allows you to change the operating frequency of the interface. All of the
brouters expected to communicate with this device should be configured with the same frequency.