User's Manual
Table Of Contents
- Chapter 1 Introduction
- Features and Benefits
- Features
- Chapter 2 Quick Start
- System Description
- Package Contents
- Installation Steps
- Installation Diagram
- Polarizations on a Grid Antenna
- Chapter 3 Hardware
- Drawings of Components
- Restoring Factory Default Settings on the SPEEDLAN
- Upgrading the Firmware
- Chapter 4 Overview of Configurator
- Installation and Setup
- Toolbar and Menus
- Chapter 5 Configuring SPEEDLAN
- General Setup
- Interface & Advanced Interface Setup
- The Setup Buttons
- Chapter 6 Bridging Setup
- Bridge Setup
- Chapter 7 Setting Up the IP Addresses (IP Host Setup)
- Part I - Quick Overview of IP Addressing
- Part II - Setting Up the IP Address
- Part III - Setting Up NAT
- Chapter 8 IP-Router Setup
- IP Routing Setup
- Chapter 9 SNMP Setup
- SNMP Setup
- Chapter 10 System Access Setup
- System Access Setup
- Chapter 11 SNMP Monitoring
SPEEDLAN Installation and Operation User Guide
5-2 Configuring SPEEDLAN
General Setup
This dialog box activates the features to configure your brouters. To select this dialog box, choose
General Setup from the Setup menu of the SPEEDLAN Configurator. Select the appropriate check
boxes as described below:
• Enable Bridging
The transparent bridging function will be enabled when this is item is selected. If you want
the brouters to perform the bridging function, you must select this check box. When
bridging is enabled, the Bridge Setup dialog box will be accessible. Bridging should be
enabled for nearly all applications of the brouter. The default is ON.
• Enable IP Routing
The transparent routing function will be enabled when this is item is selected. IP Routing will
work properly only if the routes are set up in the IP Route dialog box. If the routes are not
set up properly before you save the configuration, the router will become
inoperable. The default is OFF.