User's Manual
Table Of Contents
- Chapter 1 Introduction
- Features and Benefits
- Features
- Chapter 2 Quick Start
- System Description
- Package Contents
- Installation Steps
- Installation Diagram
- Polarizations on a Grid Antenna
- Chapter 3 Hardware
- Drawings of Components
- Restoring Factory Default Settings on the SPEEDLAN
- Upgrading the Firmware
- Chapter 4 Overview of Configurator
- Installation and Setup
- Toolbar and Menus
- Chapter 5 Configuring SPEEDLAN
- General Setup
- Interface & Advanced Interface Setup
- The Setup Buttons
- Chapter 6 Bridging Setup
- Bridge Setup
- Chapter 7 Setting Up the IP Addresses (IP Host Setup)
- Part I - Quick Overview of IP Addressing
- Part II - Setting Up the IP Address
- Part III - Setting Up NAT
- Chapter 8 IP-Router Setup
- IP Routing Setup
- Chapter 9 SNMP Setup
- SNMP Setup
- Chapter 10 System Access Setup
- System Access Setup
- Chapter 11 SNMP Monitoring
SPEEDLAN Installation and Operation User Guide
4-4 Overview of Configurator
The Toolbar
Note: The functions on the toolbar can also be accessed from the menus on the Configurator
(i.e., Save can be accessed from the File menu).
The Menu Bar
• The File Menu - This is the most common menu and is used to perform the following
functions:
• Open Config File - This opens a configuration file from disk.
• Open Remote Config - This opens the configuration file directly from a remote device.
• Save Config - This saves the configuration you are working on to the place where you
opened it.
• Save Config File as - This saves the current configuration into a file on disk. This file will
have the extension .CNF.
• Import Config File - This opens a configuration file from disk. This function is used when
you are going to save the configuration from disk to a remote brouter.
• Upload Software - This enables you to load a raw and unconfigured binary file to the
brouter. This is done only in the event that the brouter's firmware has been damaged.
• Reboot Remote - This is used to reboot a brouter from a remote location.
• Exit - This closes the SPEEDLAN Configurator.
Open
Open
Save
Save
Select
Remote
Remote
Device
Upload
Software
System
Information
Help