User's Manual
Table Of Contents
- Chapter 1 Introduction
- Features and Benefits
- Features
- Chapter 2 Quick Start
- System Description
- Package Contents
- Installation Steps
- Installation Diagram
- Polarizations on a Grid Antenna
- Chapter 3 Hardware
- Drawings of Components
- Restoring Factory Default Settings on the SPEEDLAN
- Upgrading the Firmware
- Chapter 4 Overview of Configurator
- Installation and Setup
- Toolbar and Menus
- Chapter 5 Configuring SPEEDLAN
- General Setup
- Interface & Advanced Interface Setup
- The Setup Buttons
- Chapter 6 Bridging Setup
- Bridge Setup
- Chapter 7 Setting Up the IP Addresses (IP Host Setup)
- Part I - Quick Overview of IP Addressing
- Part II - Setting Up the IP Address
- Part III - Setting Up NAT
- Chapter 8 IP-Router Setup
- IP Routing Setup
- Chapter 9 SNMP Setup
- SNMP Setup
- Chapter 10 System Access Setup
- System Access Setup
- Chapter 11 SNMP Monitoring
SPEEDLAN Installation and Operation User Guide
Quick Start 2-5
Step 4. Ground the Antenna
a) Mount the lightning arrestor to a solid surface.
b) Run the grounding wire from the lightning arrestor to a proper ground source such as a
grounding rod or roof ground wire.
c) Seal the entire lightning arrestor with the black waterproof sealant insulation putty that
comes in the installation kit. Note: The lightning arrestor is NOT
NOTNOT
NOT waterproof.
Step 5. Connect the Wireless Bridge to the Power Supply
a) Make sure the switch on the power supply is set to the proper voltage (110V or 230V AC).
b) Connect the power cord’s IEC 320 female outlet to the IEC 320 male power inlet on the
back panel of the SPEEDLAN brouter.
c) Connect the power cord to an external power outlet (110V or 230V AC).
Step 6. Connect the Wireless Bridge to any Available Outlet of the Ethernet LAN
a) Connect the RJ-45 connector on a standard Ethernet cable to the RJ-45 port on the back
panel of the brouter.
b) Connect the other end of the Ethernet cable to your Ethernet hub, switch or router.
Step 7. Repeat If Needed
Repeat Steps 1-6 for all of the SPEEDLAN brouters that will be communicating with this one.