User's Manual
Table Of Contents
- Chapter 1 Introduction
- Features and Benefits
- Transparent Ethernet Bridging with Advanced Filtering for Security and Network Reliability
- IP Routing with Advanced Filtering for Security
- SNMP Management
- SNMP Features
- SNMP Management
- IP-Router Features
- Encryption Features (Add-on Option)
- Wireless Multipoint Protocol
- Additional Functionality for SPEEDLAN 4100 & 4200
- Features
- Chapter 2 Quick Start
- System Description
- Package Contents
- Installation Steps
- Installation Diagram
- Polarizations on a Grid Antenna
- Chapter 3 Hardware
- Upgrading the Firmware
- Chapter 4 Overview of Configurator
- Installation and Setup
- Toolbar and Menus
- Chapter 5 Configuring SPEEDLAN 4100 & 4200
- General Setup
- Interface & Advanced Interface Setup
- The Setup Buttons
- Chapter 6 Bridging Setup
- Bridge Setup
- Chapter 7 Setting Up the IP Addresses (IP Host Setup)
- Part I - Quick Overview of IP Addressing
- Part II - Setting Up the IP Address
- Chapter 8 IP-Router Setup
- IP Routing Setup
- Chapter 9 SNMP Setup
- SNMP Setup
- Chapter 10 System Access Setup
- System Access Setup
- Chapter 11 SNMP Monitoring
- Remote Statistics
- Interface Monitor
- Ethernet-like Interface Monitor
- Campus PRC Station Entries
- 11Mb RF Interface
- SNMP Monitor
- IP Monitor
- IP/TCP/UDP Monitor
- ICMP Monitor
- Chapter 12 Tables
- System Information
- Bridge Learn Table
- IP ARP Table
- IP Route Table
- IP/TCP Connection Table
- IP/UDP Listener Table
- Local IP-Address Table
- Chapter 13 Analyzing Wireless Equipment
- Select Another Device
- Analysis Polling Interval
- Wireless Link Test
- Antenna Alignment
- Glossary for Standard Data Communications
- Glossary for Standard Data Communications
- Appendix Protocols & Ethernet Addresses
- Common Ethernet Protocols
- Common Ethernet Vendor Addresses
- Common Ethernet Multicast Addresses
- Common Ethernet Broadcast Addresses
SPEEDLAN 4100 & 4200 Installation and Operation User Guide
8-6 IP-Router Setup
• Listen to RIP
This function enables the brouter to listen for and update its RIP information. The routes
gathered in this manner come from other RIP-enabled routers on your network. This feature
is normally used in conjunction with Send RIP Routes, which instructs the brouter to pass
along all RIP information it has gathered to other RIP devices on your network.
• Enable Proxy ARP
This feature allows the brouter to be used as the proxy host for users on the local network.
This instructs the brouter to act as a "proxy" for the local destination host. This is used in
circumstances that require connections not normally permitted for individual users on a
network.
• Enable BOOTP/DHCP Forwarding
This feature allows the brouter to pass BOOTP and DHCP requests across the wireless net-
work.
• Forwarding Host
Defines the IP address of the device configured to act as the forwarding host for BOOTP
and DHCP messages in a routed network.
• Accept RIP For the Following Routes
Normally RIP instructs the brouter to forward all route information gathered to all RIP
devices located on you network. Specifying devices in the RIP Access List allows you to limit
which devices will be sent RIP. The devices specified in this list will be the only devices to
receive RIP, while all other devices will be denied the RIP information stored on this brouter.