User's Manual
Table Of Contents
- Chapter 1 Introduction
- Features and Benefits
- Transparent Ethernet Bridging with Advanced Filtering for Security and Network Reliability
- IP Routing with Advanced Filtering for Security
- SNMP Management
- SNMP Features
- SNMP Management
- IP-Router Features
- Encryption Features (Add-on Option)
- Wireless Multipoint Protocol
- Additional Functionality for SPEEDLAN 4100 & 4200
- Features
- Chapter 2 Quick Start
- System Description
- Package Contents
- Installation Steps
- Installation Diagram
- Polarizations on a Grid Antenna
- Chapter 3 Hardware
- Upgrading the Firmware
- Chapter 4 Overview of Configurator
- Installation and Setup
- Toolbar and Menus
- Chapter 5 Configuring SPEEDLAN 4100 & 4200
- General Setup
- Interface & Advanced Interface Setup
- The Setup Buttons
- Chapter 6 Bridging Setup
- Bridge Setup
- Chapter 7 Setting Up the IP Addresses (IP Host Setup)
- Part I - Quick Overview of IP Addressing
- Part II - Setting Up the IP Address
- Chapter 8 IP-Router Setup
- IP Routing Setup
- Chapter 9 SNMP Setup
- SNMP Setup
- Chapter 10 System Access Setup
- System Access Setup
- Chapter 11 SNMP Monitoring
- Remote Statistics
- Interface Monitor
- Ethernet-like Interface Monitor
- Campus PRC Station Entries
- 11Mb RF Interface
- SNMP Monitor
- IP Monitor
- IP/TCP/UDP Monitor
- ICMP Monitor
- Chapter 12 Tables
- System Information
- Bridge Learn Table
- IP ARP Table
- IP Route Table
- IP/TCP Connection Table
- IP/UDP Listener Table
- Local IP-Address Table
- Chapter 13 Analyzing Wireless Equipment
- Select Another Device
- Analysis Polling Interval
- Wireless Link Test
- Antenna Alignment
- Glossary for Standard Data Communications
- Glossary for Standard Data Communications
- Appendix Protocols & Ethernet Addresses
- Common Ethernet Protocols
- Common Ethernet Vendor Addresses
- Common Ethernet Multicast Addresses
- Common Ethernet Broadcast Addresses
SPEEDLAN 4100 & 4200 Installation and Operation User Guide
2-2 Quick Start
System Description
The SPEEDLAN 4100 & 4200 are high speed, long range wireless LAN brouters that provide
connectivity to remote Ethernet networks. For single point-to-point links, a SPEEDLAN 4200 can be
used in each building to create a wireless communication link. For multipoint links, a SPEEDLAN
4100 acts as the central base station, which controls the communication between multiple
SPEEDLAN 4200 brouters acting as CPE. The local brouter communicates with a remote brouter on
another LAN. This effectively creates an extended wireless network, spanning sites situated up to 25
miles apart. This enables a central Ethernet LAN to be connected with one or more branch office
LANs. A single brouter with an omnidirectional antenna, may communicate with multiple brouters to
create multipoint wireless site-to-site connectivity.
Rooftop and Tower Installations Warning
Rooftop, tower and mounted equipment (brouters) installations are extremely dangerous and
incorrect installation can result in death, injury, or property damage. These installations must be
performed by professional antenna installers only.
Package Contents
Note:
Certain items are only available when purchased with the SPEEDLAN Installation Kit.
• 4100 or 4200 SPEEDLAN brouter
• SPEEDLAN 4100 or 4200 mounting hardware
• Product registration card
• SPEEDLAN CD containing:
• Product manual
• Configuration management software
• *Electrical tape
• *Cable sealant putty
• *Lightning arrestor
• *Specialized CAT5 cable
• 10’ RF cable