User's Manual

SPEEDLAN TM

Enabling the DHCP Server on the SPEEDLAN TM

To enable the DHCP Server on the SPEEDLAN TM, do the following:

1. From the Setup menu, choose General Setup. The General Setup dialog box appears.

2. Select the Enable DHCP Server check box; this will enable you to set up the DHCP Server.

Note: The only active NAT / DHCP check boxes in the NAPT / DHCP Features section (in the

dialog box above) are the following:

• Enable Outgoing Network Address Translation - This feature enables a company to map

the private networks IP addresses into one or more global public network IP addresses. This

means that outsiders will only view the single (or more if designated) IP network address

assigned for global viewing on the Internet. For more information, see Part III - Setting Up

NAT, page 61.

• Enable Incoming Network Address Translation - This feature enables a company to unmap

public network IP address into private network IP addresses. For more information, see

Part III - Setting Up NAT, page 61.

3. From the Setup menu, choose DHCP Server Setup. The DHCP Server Setup dialog box

appears (as shown on the next page).