User's Manual

SPEEDLAN TM
19
Enable Watchdog Reboot Timer - This feature instructs the bridge to reboot in the event that the bridge fails
to receive any incoming packets, from any port, for a period of 10 minutes. The brouter will assume an error
has occured and will reboot. If, after the brouter reboots, it does not receive an incoming hello signal, the
bridge will listen for the hello signal until the user reboots the brouter manually. The Watchdog will recognize
when a signal has been re-established and will reset the timer accordingly.
Enable VGA Realtime Display - This feature allows a client to install a video card and a monitor and view
the statistics directly from the unit, instead of Configurator, laptop, PC, etc.
Note: Click Scale to view the LED Forwarding Scale.
Enable Outgoing Network Address Translation - This option enables a company to map the private
networks IP addresses into one or more global public network IP addresses. This means that outsiders will
only view the single (or more if designated) IP network address assigned for global viewing on the Internet.
For more informatoin, see Setting UP NAT, page 61.
Enable Incoming Network Address Translation - This option enables a company to unmap public
network IP address into private network IP addresses. For more information, see Setting UP NAT on
page 61
Enable DHCP Server - This option enables the DHCP client and the interface that is selected. For more
information, see Setting UP the IP Addresses, page 58.
Enable Access Point Radius Authentication - This option is not available at this time
Enable CampusPRC Radius Authentication - This option is not available at this time.
Enable Link Integrity - This option is not available at this time..
Enable IP/UDP/TCP Security Filters - This option is not available at this time.
Enable AppleTalk Security Filters - This option is not available at this time.
Enable Novell Security Filters - This option is not available at this time.