User's Manual

61
SPEEDLAN TM
SNMP IP Access List - You can optionally set up a list of networks, subnets, and hosts that are authorized
to access the brouter via SNMP.
Trap Host Password - This is the SNMP read/write password (community name) of the host that is set up to
receive SNMP Trap messages. This field is ignored if the Trap Host IP Address described above is 0.0.0.0.
Trap Host IP Address - This is the IP address of a network-connected host that is set up to receive SNMP
Trap messages from this brouter. If you do not have an SNMP Trap Host, set this to 0.0.0.0.
System Location - This field should contain the physical location of this node. (e.g., “telephone closet, 3rd
floor”).
System Name - This field should contain the administratively assigned name for this managed node. By
convention, this is the node’s fully qualified Internet Domain name (e.g., “bridge20.speedlan.com”).
Read Password - This is the read-only password
used for SNMP support. It is the SNMP password
needed to read the Flash ROM Configuration and
SNMP MIB variables. The factory-default value for
this variable is the string public.
SNMP Setup
Read/Write Password - This is the read/write pass-
word used for SNMP support. It is the SNMP pass-
word needed to write the Flash ROM configuration
and SNMP MIB variables into the bridge. The string
should be set to a value that is known only by you.
The factory-default value for this variable is the string
public and should be changed to a string known only
to you.
System Contact - This field should contain the iden-
tification of the contact person for thisSNMP-man-
aged node, together with information on how to con-
tact this person.