User Manual

SPEEDLAN 9000 Series Installation and Operation User Guide Version 3.03
Introduction 1-7
The amount of traffic a CPE is allowed to transmit within each poll interval changes
dynamically based on configuration information and the network wide traffic mix at any
specific point in time.
Figure 1-2: SPEEDView illustrating a point-to-multipoint network
Using SPEEDView, Figure 1-2 on page 1-7, illustrates a point-to-multipoint network. A
base station (indicated by blue square in the middle) polls each CPE and controls when
and which CPE can transmit.