User Manual

Version 3.03 SPEEDLAN 9000 Series Installation and Operation User Guide
4-8 Using the Configurator to Set Up Special Parameters for a Base Station
Note: If you want to reset the above parameters, click Defaults.
If you clicked Per CPE Settings Button...
Turning on Encryption
Figure 4-4: Per CPE Settings page
1 On the top half of the page: You have to authenticate an IP address for each
CPE so it is listed in the routing table. To do this, enter the hardware address
of the CPE in the Hardware (MAC) Address text box. Determine if you want
to enable or encrypt it by selecting the appropriate checkbox and click Add.
The IP addresses will not be active until the user logs on the particular CPE
router.
2 On the bottom half of the page:
If you want the router to be connected to the
network, click the Enable Node checkbox. If you want to disable the router
from the network, make sure this check box is not selected. Encyption is locked
if the lock image is displayed, and encyption is unlocked if the unlocked image
is displayed under the "Encrypt" column.
3 Click Modify to change an existing pass phrase that was set for a given CPE.
Click Create if the pass phrase has not been set for a given CPE.
Select to connect the
router to the network.
If you want to disconnect
the router from the net-
work, do not select this
check box.
Click the lock to lock
to enable encryption.