User's Manual
Table Of Contents
- Chapter 1 Introduction
- Features and Benefits
- Equipment Features
- SPEEDLAN K2's Polling Protocol -- How it Works in Star Networks
- SPEEDLAN 9000 Mesh Protocol -- How It Works in Non-Line-of-Sight Networks
- Chapter 2 Installing the SPEEDLAN 9101 & SPEEDLAN 9102 Hardware
- Rooftop and Tower Installations Warning
- Hardware Overview
- Drawings of Outdoor, Remote-Mounted Components
- The SPEEDLAN 9101 (with an Attached Standard Omni)
- The SPEEDLAN 9102 (with an External Antenna)
- Chapter 3 Using the SPEEDLAN 9000 Configurator
- Initial Configuration of the SPEEDLAN 9000
- Overview of the SPEEDLAN 9000 Configurator Main Menu
- Logging on to the SPEEDLAN 9000 Configurator
- Interfaces
- System
- Routing
- Wireless
- DHCP Server
- DHCP Relay
- NAT
- Diagnostics & Troubleshooting
- Administrative Access Pages
- Chapter 4 Using SPEEDView
- What is SPEEDView?
- System Requirements
- Installation Instructions
- Starting SPEEDView
- The Program Instructions
- The Main Tab
- Options Tab
- Admin Tab
- Chapter 5 Basics of IP Addressing
- Basics of IP Addressing
- Glossary for Standard Data Communications
- Glossary for Standard Data Communications
- Software License Agreement
SPEEDLAN 9000 Installation and Operation User Guide
3-22 Using the SPEEDLAN 9000 Configurator
Configuration
To view the configuration wireless parameters, click the appropriate interface under the Wireless
menu. Then, choose Configuration. A page similar to the following will appear.
The Wireless Configuration page allows you to select the appropriate channel and data rate for your
network.
• Reset to Factory Defaults: Click to revert to factory settings for this interface.
• Primary Firmware: This is the current primary firmware version in use by the wireless card.
• Station Firmware: This is the current firmware version in use by the wireless card.
• Channel: This is the specific band of frequencies (from 1 to 14) to determine the data path
between routers. All SPEEDLAN 9000 routers expected to communicate in each pico cell
must have the same channel (frequency).
Select one of the following channels (all are represented in GHz):
1 2.412
2 2.417