User's Manual
Table Of Contents
- Chapter 1 Introduction
- Features and Benefits
- Equipment Features
- SPEEDLAN K2's Polling Protocol -- How it Works in Star Networks
- SPEEDLAN 9000 Mesh Protocol -- How It Works in Non-Line-of-Sight Networks
- Chapter 2 Installing the SPEEDLAN 9101 & SPEEDLAN 9102 Hardware
- Rooftop and Tower Installations Warning
- Hardware Overview
- Drawings of Outdoor, Remote-Mounted Components
- The SPEEDLAN 9101 (with an Attached Standard Omni)
- The SPEEDLAN 9102 (with an External Antenna)
- Chapter 3 Using the SPEEDLAN 9000 Configurator
- Initial Configuration of the SPEEDLAN 9000
- Overview of the SPEEDLAN 9000 Configurator Main Menu
- Logging on to the SPEEDLAN 9000 Configurator
- Interfaces
- System
- Routing
- Wireless
- DHCP Server
- DHCP Relay
- NAT
- Diagnostics & Troubleshooting
- Administrative Access Pages
- Chapter 4 Using SPEEDView
- What is SPEEDView?
- System Requirements
- Installation Instructions
- Starting SPEEDView
- The Program Instructions
- The Main Tab
- Options Tab
- Admin Tab
- Chapter 5 Basics of IP Addressing
- Basics of IP Addressing
- Glossary for Standard Data Communications
- Glossary for Standard Data Communications
- Software License Agreement
SPEEDLAN 9000 Series Installation and Operation User Guide
2-16 Installing the SPEEDLAN 9101 & SPEEDLAN 9102 Hardware
If Using An Amplifier with the SPEEDLAN 9102
Items needed to install amplifier:
• one 3’ DC Power Cable
• one 3’ RF Pigtail
• one Barrel Connector
• one 10’ RF Patch cable
1 Connect the 3’ DC Power Cable from the unit/router to the amplifier.
2 Connect the 3’ Pigtail for the RF from the RF port of the unit/router to the RF “in” port of the
amplifier.
3 Connect the barrel connector to the RF “out” port on the amplifier.
4 Connect the 10’ RF Patch cable from the barrel connector to your lightning arrestor.
Note: The External RF Amp (provides an average power of +12 dBm) or External Amplifier with
Power Supply is considered an accessory and can be purchased separately, as well as the other
items included in the list above.
SPEEDLAN
8100/8200
Outdoor Etherent
Cable (from
Waterproof
Ethernet
Connector)
Lightning
Arrestor
Antenna
Amplifier
3' RF Pigtail
3' DC Power Cable
Note: If antenna lead
cable is not permanently
attached, see Attaching
Antenna Lead, Figure 8
on page 7.
Barrel
Connector
10' RF Patch
Cable
Antenna Lead
RTNC
Bulkhead
Connector
(RF Signal)
DC Output to Amp