User's Manual

SPEEDLAN 9000 Series Installation and Operation User Guide Version 3.03
Using the Configurator to Set Up Special Parameters for CPE Routers 5-11
The Max Transmit Data Rate (in Kb/s) default is set to 6500. Click Default to get the
default value. The range is from 100 to 6500 Kb/s. Then, click Apply.
Admin Menu
Software Update
Note: The Software Update zip file (found on the Wave Wireless web site under the
Support + Firmware link) will contain a document describing the recent changes and
any other additional information needed to perform the update. The zip file will also
include the update (.wwn) file to perform the update. After you have unzipped the file,
make sure you extract the update file (.wwn) file to your desktop. Then, follow the
directions below.
To update the software on a CPE, choose Software Update from the Admin menu.
The following page will appear.
Figure 5-7: Updating the software on the CPE
If you obtain a software update file from Wave Wireless Networking, you can use this
page to update software on one or more SPEEDLAN 9000 routers.