User's Manual

SPEEDLAN 9000 Series Installation and Operation User Guide Version 3.03
Using the Configurator to Set Up Special Parameters for Mesh Routers 7-7
1 2.412
2 2.417
3 2.422
4 2.427
5 2.432
6 2.437
7 2.442
8 2.447
9 2.452
10 2.457
11 2.462
• Signaling Rate: This setting refers to the wireless signaling rate. The routers
have four signaling rates that can be used. Select one of the following check
boxes:
• 1 Mb/s: This setting limits the card by providing 1 Mb/s of bandwidth.
The minimum receiver sensitivity of the radio with this setting is -92 dBm.
• 2 Mb/s: This setting limits the card by providing 2 Mb/s of bandwidth.
The minimum receiver sensitivity of the radio with this setting is -89 dBm.
• 5.5 Mb/s: This setting limits the card to providing 5.5 Mb/s of
bandwidth. The minimum receiver sensitivity of the radio with this setting is
-88 dBm.
• 11 Mb/s: This is the full 11 Mb/s signaling rate. This value is
recommended for most installations. The minimum receiver sensitivity of
the radio with this setting is -85 dBm.
Note: The network can automatically downgrade the bandwidth if needed (that is, if
lower Mb/s settings are selected).
Note: If you want to use the signaling rate and frequency settings on remote routers,
select them and click Apply to Selected Nodes. If you want to select all of the routers,
click Select All.