User's Manual

Version 3.03 SPEEDLAN 9000 Series Installation and Operation User Guide
6-4 Using the Configurator to Set Up Special Parameters for Point-to-Point Routers
For directions on this page (Secondary Point-to-Point Settings), see If you clicked the
Secondary Node Settings Button..., page 6-5.
This page contains two buttons on the top called Primary Node Settings and Secondary
Node Settings:
• Click Primary Node Settings to configure your primary point-to-point router.
For more information, see If you clicked the Primary Node Settings Button...,
page 6-4.
• Click Secondary Node Settings to configure your secondary point-to-point
router. For more information, see If you clicked the Secondary Node Settings
Button..., page 6-5.
If you clicked the Primary Node Settings Button...
Figure 6-3: Configuring Primary Node Settings (in Primary mode)
Note: The SPEEDLAN 9000 implements an advanced point-to-point mode. The
previous performance tuning parameter (latency vs throughput) was removed from the
Configurator. This means if you used firmware version 2.20 (or an older version), the
tuning parameter appeared for the primary point-to-point node. If you are using
firmware version 2.21 or higher, the tuning parameter will not be displayed. If the