User's Manual

Version 3.03 SPEEDLAN 9000 Series Installation and Operation User Guide
4-18 Using the Configurator to Set Up Special Parameters for a Base Station
This operation is a two-step process:
1 Select the remotes (CPE routers) where you want to update the software. (The
IP addresses that are selectable are active. If only a MAC address is listed, or a
bunch of zeros, then these represent inactive devices.
2 Upload the Software Update file. Locate the latest software file (by clicking
Browse) and click Upload Software Update File to Selected Nodes.
3 Install the Software Update. Note: When you updated your network in the
past, the remotes would not be rebooted until the final step. This step
happened after you clicked the Reboot Updated Nodes button. Now the
remotes are automatically rebooted after a successful upgrade. The local or
connected router is not rebooted until you click the Reboot Updated Nodes
button at the end of the upgrade.