User's Manual

SPEEDLAN 9000 Series Installation and Operation User Guide Version 3.03
Using the Configurator to Set Up Special Parameters for a Base Station 4-17
This operation is a two-step process:
1 Upload the Software Update file. Locate the latest software file (by clicking
Browse) and click Upload Software Update File.
2 Install the Software Update.
Note: When you updated your network in the past, the remotes would not be rebooted
until the final step. This step happened after you clicked the Reboot Updated Nodes
button. Now the remotes are automatically rebooted after a successful upgrade. The
local or connected router is not rebooted until you click the Reboot Updated Nodes
button at the end of the upgrade.
Updating the Software on a Base Station and CPE
To update the software on a base station and on a CPE, choose the interface (e.g., Star
Net) under Software Update submenu.
Figure 4-11: Updating software on a base station and CPE
IP address
Host name
MAC address
Firmware version