User's Manual

Version 3.03 SPEEDLAN 9000 Series Installation and Operation User Guide
3-52 General Functions of the Configurator
Figure 3-40: Advanced Services (adding AIM)
Advanced services can have one or more IP protocols. Under Advanced Services,
you will need to know the name of the service (or it can be unique), the
protocol(s) used and the ports needed to operate the service. For the TCP and
UDP protocols, you can define specific ports, or a range of ports. Enter the following
information:
1Service Name: Enter a new name for the service. (In the previous figure, the
user entered "AIM" because the user wanted to add AOL Instant Messenger.)
2 IP Protocol: Select an IP protocol for your service. If you select any protocol
other than TCP or UDP, the protocol will be immediately added to the list of
protocols for this service. (In previous figure, the user selected "UDP" because it
is the protocol for AIM.)
3 Port range: If you select TCP or UDP, you can specify a port or a port range.
Then, click Add Protocol to add that protocol and port to the list. Click Clear
to remove the IP protocol list if you need to start over. (In the previous figure,
the user entered port "5190".) If you are only entering a single port, enter it in
the left Port Range text box.
4 IP Protocols and Ports: After clicking Add Protocol, this text box will be
populated with the data, based on what you entered in the IP Protocol, Port
number and Port range text boxes.