User's Manual
Table Of Contents
- Chapter 1 Introduction
- Features and Benefits
- Equipment Features
- SPEEDLAN K2's Polling Protocol -- How it Works in Star Networks
- SPEEDLAN 9000 Mesh Protocol -- How It Works in Non-Line-of-Sight Networks
- Chapter 2 Installing the SPEEDLAN 9101 & SPEEDLAN 9102 Hardware
- Rooftop and Tower Installations Warning
- Hardware Overview
- Drawings of Outdoor, Remote-Mounted Components
- The SPEEDLAN 9101 (with an Attached Standard Omni)
- The SPEEDLAN 9102 (with an External Antenna)
- Chapter 3 Using the SPEEDLAN 9000 Configurator
- Initial Configuration of the SPEEDLAN 9000
- Overview of the SPEEDLAN 9000 Configurator Main Menu
- Logging on to the SPEEDLAN 9000 Configurator
- Interfaces
- System
- Routing
- Wireless
- DHCP Server
- DHCP Relay
- NAT
- Diagnostics & Troubleshooting
- Administrative Access Pages
- Chapter 4 Using SPEEDView
- What is SPEEDView?
- System Requirements
- Installation Instructions
- Starting SPEEDView
- The Program Instructions
- The Main Tab
- Options Tab
- Admin Tab
- Chapter 5 Basics of IP Addressing
- Basics of IP Addressing
- Glossary for Standard Data Communications
- Glossary for Standard Data Communications
- Software License Agreement
SPEEDLAN 9000 Series Installation and Operation User Guide
2-12 Installing the SPEEDLAN 9101 & SPEEDLAN 9102 Hardware
The following items are included with the installation kit, which can be purchased separately:
• cable ties (5)
• Lightning arrestor (1) current sensitive to ground
• Electrical tape (1)
• Waterproof putty tape (1)
• Specialized CAT5 cable
*Note: Antenna for the SPEEDLAN 9102 can be purchased separately.
Customer Sourced / Other
• open/closed or socket wrench to tighten the nuts on the V-bolts (5/16") (optional)
• Grounding rod clamps (can be purchased separately)
• Wall mounts (can be purchased separately)
Installation Steps for the SPEEDLAN 9102
Some installation instructions are specific to customers who purchased Installation Kits from Wave
Wireless. To view a diagram of the installation listed below, see Installation Diagram of the
SPEEDLAN 9102, page 2-17.
If you are having trouble and need a full site installation, contact Wave Wireless Networking for
services and fees.
To install your SPEEDLAN 9102 with an external antenna, do the following:
Step 1.Verifying Line-of-Sight
Before installing the antenna and unit/router, make sure a clear line-of-sight exists. Line-of-sight can
be defined as each antenna clearly seeing the other antenna, and seeing the remote locations when
viewing from the central base location. Be sure to look level with the center of origin of the
transmission (i.e., the middle of the antenna). Repeat this procedure from the remote location. Any
disruption of the signal path due to trees, building, or any other obstructions may cause the link to
function incorrectly. If you see any obstructions between two antennas, move one or both antennas
to another location.