User's Manual

SPEEDLAN 9000 Series Installation and Operation User Guide
2
Manufacturers Federal Communication Commission Declaration of
Conformity Statement
Models: SL910x
FCC Certification number: NCBSL9101, NCBSL9102
Manufacturer: Wave Wireless Networking
7020 Professional Parkway East
Sarasota, FL 34240
This device complies with Part 15 rules. Operation is subject to the following two conditions:
1) this device may not cause harmful interference, and 2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a residential environment. This equipment generates, uses, and radiates radio frequency energy, and if not
installed and used in accordance with the instructions, may cause harmful interference. However, there is no guarantee
that interference will not occur. If this equipment does cause interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to correct the interference by one of the following
measures:
Reorient or relocate the receiving antenna.
Increase separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from which the receiver is connected.
Consult the professional installer or an experienced radio/TV technician.
Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications
to this equipment. Such modifications could void the user’s authority to operate the equipment.
The part 15 radio device operates on a non-interference basis with other devices operating at this fre-
quency when using the antennas: 24 dBi grid antenna and 8 dBi omni antenna.
Caution
!
!!
!