User's Manual
Table Of Contents
- Chapter 1 Introduction
- Product Description and Contents
- Product Features
- Chapter 2 Quick Start
- Rooftop and Tower Installations Warning
- Installation Steps
- Installation Diagrams
- Chapter 3 Hardware
- Drawings of Components
- SPEEDLAN 8500 ODU Hardware
- Antenna
- Restoring Factory Default Settings on the SPEEDLAN 8500 IDU
- Upgrading the Firmware
- Chapter 4 Overview of Configurator
- Installation and Setup
- Toolbar and Menus
- Chapter 5 Configuring SPEEDLAN
- General Setup
- Interface & Advanced Interface Setup
- The Setup Buttons
- Chapter 6 Bridging Setup
- IDU Setup
- Chapter 7 Setting Up the IP Addresses (IP Host Setup)
- Part I - Quick Overview of IP Addressing
- Part II - Setting Up the IP Address
- Part III - Setting Up NAT
- Chapter 8 IP-Router Setup
- IP Routing Setup
- Chapter 9 SNMP Setup
- SNMP Setup
- Chapter 10 System Access Setup
- System Access Setup
- Chapter 11 SNMP Monitoring
- Remote Statistics
- Interface Monitor
- Ethernet-like Interface Monitor
- SectorPRC Station Entries
- 11Mb RF Interface
- SNMP Monitor
- IP Monitor
- IP/TCP/UDP Monitor
- ICMP Monitor
- Chapter 12 Tables
- System Information
- IDU Learn Table
- IP ARP Table
- IP Route Table
- IP/TCP Connection Table
- IP/UDP Listener Table
- Local IP-Address Table
- Chapter 13 Analyzing Wireless Equipment
- Select Another Device
- Analysis Polling Interval
- Wireless Link Test
- Antenna Alignment
- Glossary for Standard Data Communications
- Glossary for Standard Data Communications
- Appendixes
- Appendix A Protocols & Ethernet Addresses
- Common Ethernet Protocols
- Common Ethernet Vendor Addresses
- Common Ethernet Multicast Addresses
- Common Ethernet Broadcast Addresses
- Appendix B Startup LED Patterns
- Startup LED Patterns
SPEEDLAN 8500 Series Installation and Operation User Guide
5-4 Configuring SPEEDLAN
• *Enable Incoming Network Address Translation
This option enables a company to unmap public network IP addresses into network IP
addresses. For more information, see Part III - Setting Up NAT, page 7-20.
• *Enable DHCP Server
This option enables the DHCP Server on the SPEEDLAN. For more information, see Part III -
Setting Up NAT, page 7-20.
• Enable Access Point Radius Authentication
This option is not available at this time
• Enable SectorPRC Radius Authentication
This option is not available at this time.
• Enable IP/UDP/TCP Security Filters
This option is not available at this time.
• Enable AppleTalk Security Filters
This option is not available at this time.
• Enable Novell Security Filters
This option is not available at this time.
• Enable Watchdog Reboot Timer
This feature instructs the IDU to reboot in the event that the IDU fails to receive any incom-
ing packets, from any port, for a period of 10 minutes. The IDU will assume an error has
occurred and will reboot. If, after the IDU reboots, it does not receive an incoming hello sig-
nal, the IDU will listen for the hello signal until the user reboots the IDU manually. The
Watchdog will recognize when a signal has been re-established and will reset the timer
accordingly.