Installation Guide

WARNING : This product is only to be installed by qualified personnel.
❖ Cellular RF
This device contains a cellular RF module with FCC ID : 2AJYU-8PYA004
This device contains a cellular RF module with IC : 23761-8PYA005
FCC Caution:
1. Exposure to Radio Frequency Radiation. This equipment must be installed and
operated in accordance with provided instructions and the antenna(s) used for this
transmitter must be installed to provide a separation distance of at least 20 cm from
all persons and must not be collocated or operating in conjunction with any other
antenna or transmitter. End-users and installers must be provided with antenna
installation instructions and transmitter operating conditions for satisfying RF
exposure compliance.
2. Any changes or modifications not expressly approved by the grantee of this device
could void the user's authority to operate the equipment.
3. This Transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
4. Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user authority to operate the equipment.
The cellular antenna delivered by Wattsense meets the FCC-IC regulations.
If the installer makes the choice to use another antenna, it must follow the specifications
listed below for the device used to comply with FCC/IC regulations limiting both maximum
RF output power and human exposure to RF radiation.
1. Whip antenna type
2. 50 Ohm typical impedance
3. Maximum antenna gain
2022-04-V1.3-EN 6