Installation Guide

● Check that the ETH1 or ETH2 LED lights up.
Configuration:
● If there is no DHCP server on the network, attribute a static IP address, its mask and the
gateway if necessary to the Box (Discuss with the building’s IT manager).
● If there is a DHCP server on the network, the address is automatically assigned.
Information to retrieve in preparation for the configuration:
● For each device that communicates in Modbus IP
○ From the BMS software, perform an extract of the available properties: list the data
types provided by the different devices to which the BMS has access.
○ If it is impossible to retrieve this information, get the IP address and TCP port (and if
needed, for some devices, the slave address (Slave ID), the brand, and model of the
equipment, and extra identifying information. This information is necessary for the
installation configuration and to retrieve data.
● In the case of a BACnet IP network
○ Write down the BACnet port of the network. This information will be necessary for
the installation configuration and to retrieve data.
2022-04-V1.3-EN 23