User Manual

IS-HY-42

Series HY-42

Non-Freeze Wall Hydrants with Backﬂ ow Preventer

Sizes: Inlet

⁄4" (19mm) Female or 1" (24mm) Male I.P.S.

Installation Instructions

1. Cut an opening 2" x 4" through the foundation wall or the

floor joint band and insert the hydrant from the outside.

(see figure)

2. Position the hydrant, as shown in figure, with the anti-siphon

backflow preventer on the right hand side facing hydrant

from outside.

3. Use brackets as required to secure the hydrant in place.

(Field provide)

4. If inside connection is to be a sweat (soldered) connection,

turn hydrant tee key counterclock-wise to the fully open

position. Wrap hydrant side connection with a wet rag and

or heat sink before applying heat.

To Assure Drainage:

Detach hose from anti-siphon backflow preventer.

Series HY-42

Wall

Thickness

Top View

Front View

Cut-out View

PAGE 1
IS-HY-42 Series HY-42 Non-Freeze Wall Hydrants with Backﬂow Preventer Sizes: Inlet 3⁄4" (19mm) Female or 1" (24mm) Male I.P.S. Series HY-42 Installation Instructions 1. Cut an opening 2" x 4" through the foundation wall or the floor joint band and insert the hydrant from the outside. (see figure) 2. Position the hydrant, as shown in figure, with the anti-siphon backflow preventer on the right hand side facing hydrant from outside. 3. Use brackets as required to secure the hydrant in place.
PAGE 2
Series HY-42 Non-Freeze Wall Hydrants with Backﬂow Preventer and Mounting Box Sizes: Inlet 3⁄4" (19mm) Female or 1" (24mm) Male I.P.S. Figure 1 Cut-out View 6.25" 5.25" Figure 2 Series HY-42 Box (Front View) Installation Instruction Top View 1. Cut an opening 61⁄4" x 51⁄4" through the foundation wall or the floor joint and insert the hydrant from the outside. (see Figure 1) 2.