Installation Instructions

Page 3
NOTICE
Start up Instructions
Congratulations! You have completed the
installation of your new water filtration system.
Please Follow the Startup Instructions.
Step 1 - Turn on water supply.
Step 2 - Flush new cartridge with 5 gallons of water prior to
use and check for leaks. A container with a known
volume can be lled to determine how much water
has ushed through the system. If leaks occur,
check tightness of tubing and ttings. If leaks persist,
discontinue use and call Retail customer service.
Check frequently over the next 24 hours to ensure no leaks
are present
Product Registration
To Register your product, please visit www.watts.com/pureh2o
and select “Register Now”. Watts is concerned for the safety of
your personal information. WATTS collects personal information
when you register with Watts. This information is stored in our
data base and we do not rent, sell, or share personal information
with other people or nonafliated companies. We will send you
certain types of communications such as direct mail, email, or
by telephone relating to our products or products that you have
purchased only with your prior permission. We limit access to
your personal information to those employees who will directly
provide you with services or products in order to do their jobs.
See our privacy policy at - http://www.watts.com/privacy.asp
See Terms of Use at - http://www.watts.com/terms.asp
Changing the Filter Cartridges
6 Month System Maintenance
Replace:
Inline Granular Activated Carbon lter with Quick
connect tting H2O-FK102 (88005227)
To buy replacement part(s) please visit the retail store or their
website or contact Watts retail customer service at
[phone]
Step 1: Turn off the incoming water supply.
Step 2: Follow instructions in section ‘Filter and Quick connect
tting installation’
Step 3: After installation follow startup steps.
Performance Data Sheet
Pure H2O
-In U.S.-Watts Regulator Co., N. Andover, MA 01845
(Watts.com)
-In Canada-Watts, Water Technologies (Canada), Inc. Toronto,
ON M5J3G6 (Watts.ca)
Inline Granular Activated Carbon Filter with Quick-
Connect Fittings: H2O-FK102
This system has been tested according to NSF/ANSI Standard
42 for the reduction of the substances listed below.
The concentration of the indicated substances in water entering
the system was reduced to a concentration less than or
equal to the permissible limit for water leaving the system, as
specied in NSF/ANSI 42. Testing performed under standard
laboratory conditions, actual performance may vary.
This system is certied to NSF/ANSI standard 372 for ‘lead free’
compliance.
This system is assembled at Watts Facility- Avenida Obregon 4055 Parque
Industrial El Cid, Nogales, 84092 Mexico
WARNING
!
GENERAL USE CONDITIONS
1: System to be used with municipal or well water sources
treated and tested on regular basis to insure bacteriological safe
quality. DO NOT use with water that is micro biologically unsafe
or of unknown quality without adequate disinfection before or
after the system. While testing was performed under standard
laboratory conditions, actual performance may vary.
2: Operating Temperature: Maximum 100° F (38° C)
Minimum 35° F (2° C)
3: Operating Water Pressure: Maximum 100-psi (690 kpa)
Minimum 25-psi (172 kpa)
4: Flow Rate: 0.5 gpm (3.8 Lpm)
5: Change time interval: 2500 Gallons (9,464 Liters) or after 6
months
Description Percent
Reduction
Influent Challenge
Concentration
(mg/L unless noted)
Maximum Permissible
Product Water
Concentration
CHLORINE
TASTE &
ODOR
97.4% 2.0 mg/L + 10% > = 50%