Installation and Operation Manual

8
Leak Sensor Error
A solid red light on the sensor indicates an error has occurred. Typically, this is due to
an issue with the sensor, its circuit board, or both. If this occurs, replace the sensor.
Unpairing a Leak Sensor
If you have a leak sensor which you need to replace or no longer want to monitor, you
can unpair it from the H2iQ E800 system as follows.
1. On the Home screen, select Leak Sensor.
2. Tap the Manage Sensors button.
3. Select the sensor you want to unpair and tap Un-pair Sensor.
4. Remove the batteries from the leak sensor to disable it.
5. Tap Okay on the H2iQ E800 system screen. The sensor should no longer
appear.